Samuel and Sons
Samuel and Sons | Ardennais Studded Border
Samuel and Sons | Ardennais Studded Border
Couldn't load pickup availability
The Ardennais Studded Border is part of the Cavalleria Collection by Samuel and Sons. The collection takes its cue from medieval equestrian bridles and turns that reference into borders that combine nailheads and embroidery. Here the idea is carried out in faux leather and brass, with micro studs set into a geometric pattern. It reads as a studded border with a contemporary look, and the metal gives it a quiet, worked quality rather than anything loud.
The trimming is made of faux leather and brass. It measures 1.55 inches (40 mm) in width, and the pattern repeats every 1.2 inches (30 mm). The pattern is a border with studding, and the stated uses are cushions, blinds and upholstery. Full care instructions are available from us on request.
We would use this where a border can do some of the work of the design. On a cushion, we would run it along the edge or set it in from the seam, and keep the cloth itself plain so the studs have room to be seen. A solid linen or a quiet wool in a stone, oatmeal or deep brown would suit the faux leather and brass without competing with it. On a blind, we would place it as a single band along the lower edge, where the studding gives the shape a clear finish. For upholstery, we would think of it as a detail along an arm, a back panel or a seat edge, used with restraint on a simple, well-proportioned piece. In each case we would choose a plain, tightly woven partner cloth and let the border carry the pattern. Brass picks up warmth from timber, aged metal and softly lit rooms, so we would also look at what else is nearby, such as lamp bases, frames or door furniture, and see whether the tone sits comfortably with them.
Before ordering, we would always look at a sample in the room where it will be used, beside the cloth you plan to pair it with, and in both daylight and evening light. Check the width against the job. At 1.55 inches (40 mm) it will sit best on pieces where a border of that measure makes sense, so it is worth holding a sample against the edge or panel you have in mind. Consider too how the 1.2 inch (30 mm) repeat will fall along the lengths you need, particularly at corners and joins. If you need any other detail before you decide, ask us and we will find it for you.
Share
